CNC Router User’s Manual - IMService 121204 Router with SYS-3A controller
The complete manual guide for CNC router IMService 121204 Router with SYS-3A controller, Safety Warnings and Machine Cautions, Machine assembly and setup, System 3A User Manual. Setup, operation and maintenance. Setting up the DeskCNC controller, Determine the steps to linear motion ratios for each axis, Determine Maximum velocity (speed), Setting up the software – Machine Tab, Tool Setting, Manual Tool Measurement, Automatic tool measurement, 1) Setup the DeskCNC software BEFORE attempting to power the controller for the first time. (see DeskCNC setup section of this manual) 2) Plug the Serial Cable into the computer serial port. This may also be attached to the computer USB port by using a USB to serial converter. Attach the optional Spindle encoder cable to the Spindle connector and to the encoder on the spindle( for lathe threading).
The Axis ratios are used in the DeskCNC machine setup. In the case of the IMService servo drivers with Globe motors, the belt reduction is setup so that one revolution of the output shaft is about 2.8 revolutions of the motor shaft. The motor has a 500 line encoder. With quadrature, the motor produces 2000 counts per revolution. The 2.8:1 ratio calculates to around 2.8 * 2000 = 5600 counts per rev of the output shaft. Setting up the software – Machine Tab, Do not turn on power to the DeskCNC controller. Install the DeskCNC software, and start it. Click on Setup-Machine Setup. The drill and the spot drill are usually held in a drill chuck, and the end mill can be held in a spring collet. These tool holders all mount the tool in a different Z position each time the tool is mounted. When using these tools, the CNC operator will measure each tool, each time it is used. To Measure tool lengths after Tool-1 has been used to set the Z-zero reference plane.
DOWNLOAD LINK: http://www.imsrv.com/deskcnc/router/121204Router.pdf
Share and Enjoy...
Subscribe to:
Post Comments (Atom)
Posts
No comments:
Post a Comment